Front interior with door panel in place 11/24/08

Rear interior with door panel in place 11/24/08

Interior removed from truck 11/24/08

Factory rear seat - where the amps will eventually go 11/24/08

Interior removed 11/24/08

Removing carpet pad 11/24/08

Laying down Hushmat 11/25/08

Floor and back wall covered in Hushmat 11/25/08

Roof panel with Hushmat 11/26/08

Wiring for Alpine PXA-H701 processor ran 11/28/08

Speaker wiring for front left stage ran 11/28/08

Three grommets in place for 1/0 gauge power and ground cables 12/1/08

Speaker wire in place on passanger side for front stage 12/1/08

Floor vents going back into place after sound deadening 12/1/08

Laying the carpet pad 12/1/08

Carpet back in place 12/1/08

Passanger side kick panel taped and ready for fiberglass 12/4/08

Driver side kick panel taped and ready for fiberglass 12/4/08

All wiring in place in rear of truck - amp wiring, speaker wiring, and processor cables 12/4/08

Fiberglass layer on the passanger side kick panel 12/5/08

Fiberglass layer on the driver side kick panel 12/5/08

Aiming the kick panels before making their enclosure 12/23/08

The basic frame for the kick panel enclosures 12/23/08

Prepairing to build the enclosure 12/23/08

Adding fiberglass to the kick panel enclosures 12/23/08

Kickpanel fiberglassed and drying 12/26/08

Modified grille to mount tweeter 12/26/08

Front side of modified grille for kick panels 12/26/08

Driver side kick panel covered in vynal 12/26/08

Driver side kick panel with speaker in place 12/26/08

Passanger side interior 12/31/08

Driver side interior 12/31/08

Driver Side door closed 12/31/08